← vanagon.com home · Continue the discussion in the forum
VanagonEuroVan
Sort by authorSort by posting dateSort by topicChronological orderMost recent firstShow authorHide authorShow table of contentsHide table of contentsBack to main VANAGON pageJoin or leave VANAGONSearch
Subject:Re: Wipers suddenly not working, trip tomorrow
From:George Laubach <skiplaubach@COMCAST.NET>
Date:Sat, 1 Jun 2013 19:44:26 -0500

Mike, let me know if you need me to scan and email any Bentley pages. Just give me a call. 

(note to team:  Mike graciously sent me two 1.9s (and accessories) - well his wife made him make room in the garage...when he did his Bostig and auto to manual conversions. I ended up using one of his engines in my 1.9 to 2.2 conversion.)

Sent from my iPad

On Jun 1, 2013, at 7:33 PM, Mike South <msouth@GMAIL.COM> wrote:

> On Sat, Jun 1, 2013 at 4:12 PM, David Beierl <dbeierl@attglobal.net> wrote:
> 
>> At 03:46 PM 6/1/2013, Mike South wrote:
>> 
>>> hit me with everything you would do to check why wipers would not be
>>> working.  They were working a few days ago.
>>> 
>> 
>> 
>> Page 97.66
>> 
>> 
>> Wipers have worked since the dash went back on, yes?
>> 
> 
> Yes--at least I'm 90% sure that they did.
> 
> 
>> 
>> Do the heater blower and rear defrost work?
> 
> 
> Nope.  Heater blower does not work, and I am sure I tested that after the
> dash was on because I used the switch on the outside of the dash to do it.
> 
> 
>> If so, the load reduction relay and its drive from the X terminal of the
>> ignition switch is good.
>> 
> 
> I pre-emptively replaced the ignition switch with a new one when I was
> putting the dash back on.  I know that new does not equal good, and also
> that you should suspect the part you put on last, first.  How can I test if
> power is coming off that terminal?
> 
> Also where is that load reduction relay, and how would I check it?
> 
> 
> 
>> 
>> 
>> Does washer pump work?  If so then you've eliminated fuse S10 as a problem.
>> 
> 
> If S10 is the tenth fuse starting from the driver's door, the fuse looks
> ok.  However, with the key on, there is no power on either end of the fuse.
> 
> 
>> 
>> Is the wiper switch connector plugged in all the way on the column?
>> 
> 
> Which one is that?  I did find one that was not all the way in.  I plugged
> that one (the square-cross-sectioned black one on the driver's side) all
> the way in and it made no difference.
> 
> Thanks for all your suggestions.
> 
> mike
> 
> 
>> 
>> Yours,
>> David
>> 
>> 
>>

← Previous in threadNext in thread →
Back to June 2013, week 1
Have something to add on this topic today? Revive this thread in the forum »